- 132
- 362 419
DIYDime
United States
Приєднався 7 бер 2010
Dash Camera Installation Infinity QX50 #diy #automobile #viral #video #viralvideo
a.co/d/00ldhuh3
Переглядів: 45
Відео
Audi A6 3.0TDI How To Change Injector Copper Washer 
Переглядів 246День тому
Audi A6 3.0TDI How To Change Injector Copper Washer 
How To Make 0-16V HighAmp Power Supply #automobile #viralvideo #diy #video #viral #funny #top
Переглядів 50714 днів тому
Converting a 164A, 12.2V Power Supply to 0-16V Variable Voltage IBM Delta DPS-2000BB 200-240V 50-60HZ 2000W 12.2 V 164A Power Supply Inside the power supply, there are components that can store life-threatening voltage for a long time, even when turned off. Therefore, only individuals who are aware of the risk and have sufficient expertise should attempt the conversion!
Power Supply Cooling Fans Installation & conversion
Переглядів 491Місяць тому
Power Supply Cooling Fans Installation & conversion
Audi A6 3.0TDI Timing chain replacement
Переглядів 174Місяць тому
Audi A6 3.0TDI Timing chain replacement
Monster 40 Gal PowerWash Using Old 1970 Engine
Переглядів 332Місяць тому
Monster 40 Gal PowerWash Using Old 1970 Engine
AUDI A8 Timing Chain Removal Timelapse
Переглядів 1,1 тис.Місяць тому
AUDI A8 Timing Chain Removal Timelapse
Injector seals replacement Audi, BMW, MB
Переглядів 38Місяць тому
Injector seals replacement Audi, BMW, MB
How to Fix your Keurig K Duo Essentials coffee machine
Переглядів 172Місяць тому
How to Fix your Keurig K Duo Essentials coffee machine
How to remove BMW X5-X7 steering wheel an airbag
Переглядів 2342 місяці тому
How to remove BMW X5-X7 steering wheel an airbag
BMW X7 Sunroof (initialization ) calibration
Переглядів 822 місяці тому
BMW X7 Sunroof (initialization ) calibration
BMW Brake Fluid Instrument Cluster Message Reset
Переглядів 562 місяці тому
BMW Brake Fluid Instrument Cluster Message Reset
BMW Gesture Control Camera Replacement
Переглядів 1122 місяці тому
BMW Gesture Control Camera Replacement
BMW X7 Floor Air Vents Plastic Covers Installation
Переглядів 962 місяці тому
BMW X7 Floor Air Vents Plastic Covers Installation
BMW X7 Rear Cabin Filter replacement (5-zone climate)
Переглядів 1782 місяці тому
BMW X7 Rear Cabin Filter replacement (5-zone climate)
BMW X7 How to remove auxiliary lithium battery including metal box
Переглядів 1882 місяці тому
BMW X7 How to remove auxiliary lithium battery including metal box
Cracked Wheel hub cap replacement Kenworth T680
Переглядів 572 місяці тому
Cracked Wheel hub cap replacement Kenworth T680
A/C belt idler and tensioner bearing replacement Kenworth T680
Переглядів 732 місяці тому
A/C belt idler and tensioner bearing replacement Kenworth T680
Cummins X15 Water Pump Replacement #kenwortht680 #diy #automobile
Переглядів 8452 місяці тому
Cummins X15 Water Pump Replacement #kenwortht680 #diy #automobile
How do you know how much water to add? I've added about 50ml to each cell, but the top of the "plates" are still dry. I realize it's different with an AGM and they should not be fully flooded.
Try to charge now and after charging, test the battery. The goal is to get results, not to flood the cell. If no change in battery- repeat the process.
Hello. I have a 2019 A8L I replaced the front left air suspension and now the car won’t get up on the front on both side left and right. How do I can get security code please.
Hello, unfortunately I don’t know the code, because it’s newer style. Try to google it or forums.
Thank you for the response I’ll attach a picture of the codes I have on the suspension
C10D3F6 Level control system Left front boosting implausible. Active C10D3F7 Level control system Right front boosting implausible. Active C11D2F1 Front axle ride-height control system extremely low level detected. Active B200300 Function locked. Active C1046F6 Level control system Axle load determination not performed. Active C10400 control position not learned. Active
I really appreciate the video. You were very helpful
I believe I need to calibrate the vehicle but I’m not sure if my Autel will do it but I have all the options you went through on your end the only thing that didn’t work is the security code
You can't just change the pump. There are three o rings on the back of the water pump housing that also need to be changed.
In my case I had a water pump leaking, not a housing. Some people buying housing and changing housing too when they have only problem with the pump which is unnecessary.
@DIYDime It's not unnecessary. If the o ring on your water pump has gone flat then the 3 o rings on the housing will soon go flat as well. Doesn't make much sense to wait till later to change the housing o rings and have to repeat the process. I fully understand that at the time that it's only the water pump leaking but it would only take the removal of I think 7 13mm bolts to prevent a leak in the near future. What you're showing these guys is an incomplete job.
Thank your video dude I saved $1000 Can dollars. 🤘
Glad I could help
Херь какая то
👍🔥
Cool 🔥
how many airbag plugs are in a 2021 BMW x7 M50i? I’m asking cause a company that’s making me a carbon fiber steering wheel is asking for the airbag plugs on the steering wheel.
As you see on the video, the airbag itself have three connectors, which is branches to only one connector that go to the steering wheel. Besides that the steering wheel itself have lots of connectors.
@@DIYDime yeah I see. Thank you I’ll be subscribed
@Quxesss Please subscribe if you could, I’ll be adding more BMW X7 videos as we go.
Thanks
hi brother can u share the timing chain guide if u have pdf form will be helpful
Wow thank you so much. Tried this on my solocam pro with the solar panels and I was able to swap out the batteries.
Hey I have a t680 2019 with the same problem with the air gauge secondary and you said you sell them?
a.co/d/0csqxjk3
My fiancée's deceased husband left her one of these (a 3.2, actually) when he died. Cruelest joke ever.
How did you come up with this solution?
I found a german language PDF file, where someone from 🇩🇪 describing in details how to do that.
Best video about changing a semi brake chamber on UA-cam. Step by step. I need the adjustment part. And why do I see people cut the stroke?
Thank you. This is welded clevis brake chamber, but some semis and trailers have different brake chambers people are cutting a stroke to make a shorter so it can fit for their vehicle. Unfortunately I don’t have a video how to adjust a brake shoe yet.
Thanks
Way to go showing us how to remove the 2 most difficult bolts!
Good to know! I’ve got a dead camera that’s outside warranty and the charging port is corroded, won’t charge 😔.
Sadly I couldn’t get my EufyCam 2 Pro to open with your method…
Hello. After you left your battery with more than 13.5v, you turned on the vehicle and it was automatically available to install?
No I had to reboot I drive by holding volume button.
how much fill capacity?
1 Liter or fill until it’s running out.
@@DIYDime how did you position the straw, I can’t seem to get it past the middle part
@@paxrom1It is soft flexible hose that connected to the soap pump.
Hi, did you disconnect the auxiliary batter before charging the main battery? Does it matter? I’ve got my battery charging but just noticed I haven’t disconnected the auxiliary ground yet. Thanks for the tutorial!
If you charging your main battery which is located in the trunk you do not need to disconnect your auxiliary battery.
Thanks. I disconnected it anyways. Trying now. I haven’t yet been able to get the safety click like you in the video tho
What’s the part number for the camera?
I didn’t buy camera. I bought used overhead console of a eBay and pulled camera from there.
Price
SL Euthtion 3000W Pure Sine Wave... www.amazon.com/dp/B09B5Y3MWD?ref=ppx_pop_mob_ap_share
Do you know how to reflash the leveling control module
Same as the other modules but you need to have correct file software (version).
How did you get it to charge? I followed everything that you did but did not hear the safety switch click for the lithium battery to take the charge. Do you have to have both battery charging at the same time for it to work?
What charger are you using? You need to set at list 14.2 volts on your power supply in order to deactivate safety switch. Check your battery terminals with volt meter and make sure it’s showing 0Volts, because if it’s not and your battery showing voltage then you might have other problem. Go to your I drive manual in the car and search for software upgrade or something like that and it should tell you exactly what procedures need to take in order to finish update
@@DIYDime I’m using the same charger as yours and I had it set the same as you do. 14.7v and 2Amp. I have the X7 as well.
When you test the battery with a Voltmeter what does it show? 0V or 12-13.2v?
@@DIYDime it is showing 0v with the output button being off. Then it will show 15v with the output button being ON. But, safety switch isn’t disengaging so Battery isn’t taking the charge.
@@DIYDime how much charge did you put in you L ion battery? I know you said 13.2 V should be the minimum, did you go above 14v to get the software to update?
I created a tool with a small bolt with a 14mm head and two nuts locked together to loosen the fill bolt. Also ista does have a service function to reset TC clutch adaptations.
Nice
How much those cost?
$500, Kenworth dealer in Florida.
@@DIYDime brought my 2019 international isk15 last year had 604k miles I think it’s time now?
Sorry I have another video (water pump replacement) and I mistakenly thought you are asking me about water pump price which is $500. Valve adjustment price I don’t know since I did it myself
@@DIYDime oh ok gotcha
Hello, what timing chain kit did you use?
Febi
Okay but they dont have sprockets in their kits only chain and tensioners and are they good quality?
I did not change the sprockets! only the chains and tensioners! yeah, it’s a good quality also
Thank you but dont the sprockets wear and when they are weared and change with new chains dont they wear chain faster?
@@MartinManchev-bv3wt inspect them if they are bad change them also but otherwise you should be fine. I didn’t do it on my a8 and a6. Only chains and tensioners.
Exactly what I was looking for! Thank you
Great to hear!
You the best teacher ❤❤.
Thank you! 😃
Did the car throw any light when you took the controller off/on?
You need to disconnect both of your batteries before you proceed take the overhead console. No lights the only thing you will need to initialize your sunroofs. I have a video on my channel how to do that.
Great video. Thanks for sharing your knowledge. I couldn't see clearly from the video what did you use for the car to set on, just a regular jack and a bottle jack on each side?
Yes
Is there enough room to work on upper arm bolts by just removing the wheel well cover, or is the air shock needs to be loosened as well?
@@dumitrumalcoci7873 I had no problem removing bolts but a lot of people saying that’s hard to get it out. If it is, then just unscrew 3 nuts on the top and that will help to get the bolts out.
Thank you!
Completely useless videos! Tell me please what should someone do with this video? Stupid music and everything on a fast forward. People need information, explanations. Otherwise why will someone want to watch a video like this?
What is your Facebook account please! How I can buy from you?
What if you just let the needle not working? While you know there is no problem with air gauges?
It will work even when the needle is not working AS LONG AS YOUR AIR SYSTEM works, but this is not correct and I do not recommend driving like that because when your air system goes bad you might not know that, also it will lead to DOT out of service I believe!!!
What is your account on facebook buddy? How I can buy from you this part?
For a 7 minutes video, 6 minutes minutes for just installing fans. How about the variable supply?
Will do soon in the next part.
High Amperage - Variable Voltage Power Supply ua-cam.com/video/Xa9Y7ri2rck/v-deo.html
👍
Why raise wheel
I did it to stop the oil leak, so I can dry out area and put the seal. Plus, you can check the wheel bearing on the wheel.
Great video, with instructions. Thank you bro!
Glad it was helpful!
Hi where did you buy the power supply ?
DC Power Supply Variable, 30V 10A... www.amazon.com/dp/B0B7WBDXWN?ref=ppx_pop_mob_ap_share
Thank you so much
What leads did you use to go from the DC power supply to the LiON battery?
That cable with small alligator clamps came along with power supply. I bet you could find them on Amazon or Allixpress
a.co/d/3db8Wrx
Do u know the belt size
Kenworth T680 AC compressor replacement. #kenworth ua-cam.com/video/u1eqK9XktVA/v-deo.html
Thats why these things are cheap secondhand. Moneypits.
on C7 worked. Same procedure.
Nice old Perkins
What is the fluid capacity?
1 Liter
@@DIYDime thank you! How about the rear differential?
The same
What is the fluid capacity?
1 Liter
Maybe I missed, what mileage should you do that?
@@andreysinicin9419 if I’m not mistaken, BMW says it’s lifetime, but I know some people do between 25K-50K. If you planing on keeping it a vehicle for a long time I would suggest doing it soon, as we know to the forums, peoples feedback there are many problems with a front differential black oil issue at the low mileage and also below level liquids. When you service liquids, make sure your vehicle is on level surfaces.
Great DIY video...but this is the reason my father told me "Son don't get involved with European vehicles...!"
Imagine putting all back together and missing something!
Can you send a link to buy the replacement?
You need to look on eBay cheap working condition overhead console and pull the camera from there. That’s how I did it.
@@DIYDime does it have to be x7’s module or may with gesture control will work?
I don’t know brother, can’t tell you 100%. I did buy used console for X7 same as my vehicle.
@@DIYDime thank you sir!